REFLECT LIGHT
REFLECT LIGHT: a retro-re ective varnish in aerosol spray format.
This light-re ecting coating is highly effective in the dark. The light from any beam
(torch, vehicle headlights, etc) is re ected due to diffraction by the glass microbeads present in the clear varnish.
It can be used for a wide range of different uses to create an effect similar to that of road signs: to indicate a hazardous area, to mark a pathway or other area for safety purposes, or for marking-out sports or cultural events.
It provides a simple “safety” solution when there are natural obstacles or other speci c risks that need to be seen in poor visibility, whether indoors or outside.
PROPERTIES
• Good durability over time: 6 to 12 months
(depending on application surface and
conditions).
Can be applied to a wide range of surfaces
(concrete, wood, asphalt, metal, stone, etc).
(On plastic or painted surfaces, it is advisable to
test beforehand to check compatibility).
• Application temperature: -15°C to 50°C.
• Apply one light coat. Good adhesion.
• Rapid drying: 5 min.
• Immediately becomes highly re ective at night,
under a direct beam of light (30 m to 40 m).
SPECIFICATIONS
Composition
Binder: acrylic.
Pigments: a speci c blend of several types of
specially treated glass microbeads, free from
lead and cadmium.
Solvents: a complex mix free from chlorinated
solvents and aromatic compounds (toluene,
xylene, etc).
Propellant: a speci c blend of isobutane and
propane.
Application method
• Apply by hand or using our application
equipment (hand gun, stencils).
Vertical use (head-up).
• Before use : shake the aerosol vigorously and continue shaking for about fteen seconds, even after having clearly heard the ball bearings, to ensure the paint is well-mixed (particularly the glass microbeads).
• Shake the aerosol regularly during use.
• During and after use: purge.
• Apply to a clean, dry surface.
• Apply very light even coats (successive lightly applied layers) approximately 10 cm to 20 cm from the surface to develop maximum reflectivity.
• In daylight it should be barely visible.
• It may be necessary to protect adjacent surfaces to prevent possible overspray (mist).
• The retro-re ective effect can be veri ed by holding a torch at eye-level and pointing the light beam directly at the painted surface, once it is dry.
Health and safety
Safety data sheets are available on the internet
free of charge: www.quick-fds.com.
CLP labelling with two pictograms.